Here’s a little diversion, prompted by an email from Mark Andrews of Marks Model Works asking ‘Can you print this?’ My initial reaction was ‘No’ but after having a closer look I was thinking ‘Maybe’ and sure enough it turned out OK. The shafts on the model are 0.6 mm square maximum, so this is…
In the last few weeks I’ve started to make serious progress on the W. The following photos are somewhat hastily posed. I’m still waiting for dome and other castings, the smokebox door is blutacked in place and the cab roof is just placed. The eagle -eyed will spot other deliberate mistakes, but the purpose here…
While drawing up some buildings for current projects, Haydn and I embarked on this little 1:64 dunny as a test piece. The floor is about 15mm square. It is printed at 25 micron in X and Y with 20 micron layers. It was printed this way to simplify painting. Careful inspection will show that the…
